| 12345678910111213141516171819202122232425262728293031323334353637383940414243444546474849505152535455565758596061 |
- config IR_IMG
- tristate "ImgTec IR Decoder"
- depends on RC_CORE
- select IR_IMG_HW if !IR_IMG_RAW
- help
- Say Y or M here if you want to use the ImgTec infrared decoder
- functionality found in SoCs such as TZ1090.
- config IR_IMG_RAW
- bool "Raw decoder"
- depends on IR_IMG
- help
- Say Y here to enable the raw mode driver which passes raw IR signal
- changes to the IR raw decoders for software decoding. This is much
- less reliable (due to lack of timestamps) and consumes more
- processing power than using hardware decode, but can be useful for
- testing, debug, and to make more protocols available.
- config IR_IMG_HW
- bool "Hardware decoder"
- depends on IR_IMG
- help
- Say Y here to enable the hardware decode driver which decodes the IR
- signals in hardware. This is more reliable, consumes less processing
- power since only a single interrupt is received for each scancode,
- and allows an IR scancode to be used as a wake event.
- config IR_IMG_NEC
- bool "NEC protocol support"
- depends on IR_IMG_HW
- help
- Say Y here to enable support for the NEC, extended NEC, and 32-bit
- NEC protocols in the ImgTec infrared decoder block.
- config IR_IMG_JVC
- bool "JVC protocol support"
- depends on IR_IMG_HW
- help
- Say Y here to enable support for the JVC protocol in the ImgTec
- infrared decoder block.
- config IR_IMG_SONY
- bool "Sony protocol support"
- depends on IR_IMG_HW
- help
- Say Y here to enable support for the Sony protocol in the ImgTec
- infrared decoder block.
- config IR_IMG_SHARP
- bool "Sharp protocol support"
- depends on IR_IMG_HW
- help
- Say Y here to enable support for the Sharp protocol in the ImgTec
- infrared decoder block.
- config IR_IMG_SANYO
- bool "Sanyo protocol support"
- depends on IR_IMG_HW
- help
- Say Y here to enable support for the Sanyo protocol (used by Sanyo,
- Aiwa, Chinon remotes) in the ImgTec infrared decoder block.
|
